TomTom ONE 140S User Manual download pdf (Page 6)

Before you start3.

Before you start

Switching on and off

Install your TomTom ONE/XL/XXL navigation device in your car following the

instructions in the installation section at the start of this book.

To switch on your navigation device, press and hold the On/Off button until

you see the start-up screen. The first time you switch on your device, it may

take a short time to start.

To set up your device you need to answer a few questions by tapping the

screen.

Device not starting

In rare cases, your TomTom ONE/XL/XXL navigation device may not start cor-

rectly or may stop responding to your taps.

First, check that the battery is properly charged. To charge the battery, con-

nect your device to the car charger. It can take up to 2 hours to fully charge the

battery.

If this does not solve the problem, you can reset the device. To do this, press

and hold the On/Off button for 15 seconds and release the button when your

device begins to restart.

Charging your TomTom ONE/XL/XXL

Before you use your ONE/XL/XXL for the first time, it’s a good idea to charge

it fully.

The battery in your TomTom ONE/XL/XXL navigation device charges when

you connect it to the car charger or to your computer.

There is no charging light on your ONE/XL/XXL. To check the battery status

and see when your ONE/XL/XXL is charging, switch on your device and tap

the bottom right-hand corner of the screen in the Driving View. The battery

status is shown on the next page.

When you connect your device to a computer, you are asked if you want to

connect to the computer. If you select No and then do not tap the screen

within three minutes, the device will automatically switch off. This happens so

that the battery can charge faster.

Note: You should plug the USB connector directly into a USB port on your

computer and not into a USB hub or USB port on a keyboard or monitor.

1 2 3 4 5 6 7 8 9 10 11 ... 65 66

No comments

TomTom ONE 140S User Manual Page 6